The Nucleus-M is a revolutionary and highly customizable 3-channel
wireless lens control system. It allows you to have full control of
focus, iris, and zoom on either the FIZ hand unit or between the two
wireless hand grips. You can even split control of the channels between
the hand unit and wireless hand grips as you see fit with the push of a
The wireless range of both the hand unit and hand grips
is 1,000 feet and with the planned upcoming transmission upgrade, the
range can reach up to 1 ¼ miles! This makes it ideal for drone or
The hand grips can be attached to the included
rosette mounts for handheld operation and can also be attached to top
bar-based gimbals with the included Nucleus-M Hand Grip to Gimbal Adapters or to ring-based gimbals with the optional Nucleus-M Hand Grip Universal Gimbal Ring Adapters.
motor has its own built-in motor drive that communicates directly with
the hand unit and hand grips. This negates the need to mount a separate
MDR to your rig, allowing for a more compact camera setup and a quicker
setup time. Simply set the motors and hand unit/hand grips to the same
channel and you will have full control.
The motors allow for
automatic calibration of the lens as well as manual calibration if you
are using lenses that don’t have hard end stops at close focus and
The motors are designed to clamp onto 19mm or 15mm rods
(with the included rod bushings). This clamp-on design allows you to
easily attach and detach the motors without needing to remove any other
accessory from your setup. Every motor has a 0.8 mod, 35 tooth, 32 pitch
gear attached, which is the standard gear size for cinema lenses. The torque of the Nucleus-M Motor at 14.8V is 2.5N·m
power the motors, only one power port on your camera rig needs to be
used. Simply plug the P-tap power cable into one of the motors and then
daisy chain power to the rest of the motors with the short 7-pin to
7-pin cables. The motors can be powered through a power source that has a voltage output ranging from 7.2V-24V.
The hand unit and hand grips are each powered with two 18650 rechargeable batteries (batteries NOT included). When fully charged, the batteries in the hand grips last up to 2 days, while in the hand unit they last up to 10 hours.
start/stop is possible by plugging a compatible Nucleus-M R/S cable
into the open 7-pin port of a motor. This then gives you R/S
capabilities through the hand unit and/or the handles.
PLEASE NOTE: The R/S cables we offer for our wooden handles ARE NOT
compatible with the Nucleus-M since the engineering and pin
configurations are completely different. Using the wooden handle R/S
cables are not safe to use with the Nucleus-M. Only use cables that have
been developed by us exclusively for the Nucleus-M system.